SILENT KNIGHT 4720 Installation Manual download pdf (Page 15)

Regency

Model 4724 Control Expander Installation Manual (P/N 150596-02, Rev. A) Revised 8/98

3.3.2 Suppliers of X-10 Modules

X-10 compatible modules can be obtained from Interactive Technologies, Inc. by contacting

ITI’s Order Entry Department at 800-777-4841.

3.4 Software Updates

If you are installing the 4724 on to a Revision L (or earlier) 4720 board and you want to print

zone numbers greater than 99 or use the Answering Machine Bypass feature, you will need to

replace the Model 4720 Dialer Microprocessor Chip (P/N 4793) with the Model 4725 Dialer

Chip. To order the 4725 Dialer Chip, contact ITI’s Order Entry Department at 800-777-4841.

Section 4: Touchpad Operation

4.1 Touchpad Designations

The 4724 allows the system to use both door/card access (up to 255 cards).

Each touchpad location (up to 15) has several programmable options. Touchpads designated as

door stations will allow codes to be used for door access. A programmable option allows sin-

gle-swipe access and disarm at door stations. The Exit feature on door access touchpads can be

programmed to generate a report and printout. Each card (code) must be assigned a group of

areas to which it is granted access. The card will work only at stations assigned to one or more

of the same areas.

Touchpads not selected as door stations will allow cards to be used for arming and disarming,

but not door access. Cards swiped at these stations will arm or disarm the system, depending

on the card's current privileges. Touchpads that are selected as door stations (not door only)

will allow codes to arm and disarm, if appropriately programmed. You can arm or disarm the

system by pressing the DOOR key and entering the appropriate code (usually Code 0 or Code

1).

Touchpads designated as intercom stations will be able to use the Intercom features, but will

not have door access capabilities.

NOTE Any station can access X-10 Modules or Model 4150 relays.

Alarms and touchpad troubles are annunciated by location. Panic keys report as separate zones

for each station. Duress alarms caused by entering the duress prefix also have a separate zone

ID for each touchpad Table 1, “Panic Key Zones,” lists the zone reported for each touchpad.

The zone numbers can be found from Table 1 or through the following formula:

Zone = (Station ID #) x 4 + 145 + Keynumber

Keynumber 1 is for “POL,” 2 for “AUX,” and 3 for “FIRE.” The station ID is set for 0-15,

using the DIP switches on the back of each touchpad.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 81 82

No comments

SILENT KNIGHT 4720 Installation Manual Page 15