SILENT KNIGHT 4720 Installation Manual download pdf (Page 17)

Regency

Model 4724 Control Expander Installation Manual (P/N 150596-02, Rev. A) Revised 8/98

4.2.4 Display Events

To display the event memory, press 1 MEM. The events will be displayed starting with the

oldest event and continuing to the newest event. The event is displayed along with the date and

time it occurred.

After pressing 1 MEM, you must enter a start date to begin the event display. Press the digits

of the month, day, and year, then press TEST. All events on or after this date will be shown.

To show all the events in memory, press CLR TEST.

NOTE If you are using software revisions A-G, you cannot enter the year when viewing events.

4.2.5 Clear Events

1. To clear the event memory, press 1 0 TEST and enter a code with Program mode access.

2. Press 1 to erase the memory, press 0 to quit, or press the TEST key to continue.

4.2.6 Zone Display

Press 1 STAT to display all zone locations assigned to the same areas as the touchpad.

4.2.7 Touchpad Display

Press 2 STAT to view the location of the touchpad you are currently using.

4.2.8 Software Revision

Press 4 STAT to view the 4724 software revision date.

Section 5: Area Control

An area is a part of a building that is being treated as a subsection of the total system. The

Model 4724 allows an installation to be divided into up to eight areas. There are two possible

levels of system operation using areas: split and simple system arming.

5.1 Levels of Area Control

5.1.1 Simple System

Area programming is used to divide system door access into separate areas. Codes and touch-

pads for each area are programmed to determine who will to gain access at the touchpad. Arm-

ing and other functions operate at all stations and apply to the entire system, not to individual

areas.

5.1.2 Split Arming

Split arming offers a high degree of independent operation for each area. Each area can be

independently armed and disarmed. Each area has its own entry and exit timer. Entry or exit

zones assigned to that area will be disabled during the entry or exit time for the area. The pro-

grammed entry and exit times are shared by all areas.

Interior and Instant operation are also controlled separately for each area. Each area has its

own interior zones and interior active status. Each area has its own instant status that disables

the entry and exit timers for that area.

CODE2 operation applies separately for each area. When the Code2 feature is activated,

Code2 restricted access codes may disarm the area once. Normally Code2 restricted codes can

never disarm the system.

Each area can be armed and disarmed using only touchpads and codes that have been assigned

to that area.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

No comments

SILENT KNIGHT 4720 Installation Manual Page 17